ASTM D7179-18 PDF

Scope: 1.1 This test method is used to measure the breaking force of a geonet. 1.2 This test is applicable for manufacturing quality control (MQC) and construction quality assurance (CQA) testing, and is not recommended as a performance test. 1.3 The values stated in SI units are to be regarded as standard. The values given in parentheses are for information only. 1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

ASTM D7179-18 Referenced Document

ASTM D4354 Standard Practice for Sampling of Geosynthetics for Testing
ASTM D4439 Standard Terminology for Geosynthetics*， 2024-02-01 Update
ASTM D76/D76M Standard Specification for Tensile Testing Machines for Textiles*， 2021-07-01 Update

2018 ASTM D7179-18 Standard Test Method for Determining Geonet Breaking Force
2007 ASTM D7179-07(2013) Standard Test Method for Determining Geonet Breaking Force
2007 ASTM D7179-07e1 Standard Test Method for Determining Geonet Breaking Force
2007 ASTM D7179-07 Standard Test Method for Determining Geonet Breaking Force
2005 ASTM D7179-05 Standard Test Method for Determining Geonet Breaking Force