ASTM D1246-16(2021)e1 PDF

Scope: 1.1 This test method is applicable to the measurement of bromide ion in water, ground water, and drinking water. 1.2 Samples containing 0.5 mg/L to 1000 mg/L of bromide may be analyzed by this test method. The concentration range may be extended by the dilution of an appropriate aliquot. 1.3 The precision and bias statements were determined on natural and ground waters. It is the responsibility of the analyst to assure the validity of this test method for untested matrices. 1.4 A titrimetric and two colorimetric test methods for iodide and bromide were discontinued. Refer to Appendix X1 for historical information. 1.5 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard. 1.6 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.7 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

ASTM D1246-16(2021)e1 Referenced Document

ASTM D1066 Standard Practice for Sampling Steam
ASTM D1129 Standard Terminology Relating to Water
ASTM D1193 Standard Specification for Reagent Water
ASTM D2777 Standard Practice for Determination of Precision and Bias of Applicable Methods of Committee D-19 on Water
ASTM D3370 Standard Practices for Sampling Water from Closed Conduits
ASTM D4127 Standard Terminology Used with Ion-Selective Electrodes
ASTM D5810 Standard Guide for Spiking into Aqueous Samples
ASTM D5847 Standard Practice for Writing Quality Control Specifications for Standard Test Methods for Water Analysis