ASTM D3319-11(2017) PDF

Scope: 1.1 This practice covers a laboratory procedure by which an estimate may be made of the extent to which different coarse aggregates may polish. 1.2 The values stated in inch-pound units are to be regarded as the standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard. Regarding sieves, per Specification E11, “The values stated in SI units shall be considered standard for the dimensions of the wire cloth openings and the diameter of the wires used in the wire cloth.” When sieve mesh sizes are referenced, the alternate inch-pound designations are provided for information purposes and enclosed in parentheses. 1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. 1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

ASTM D3319-11(2017) Referenced Document

ASTM C778 Standard Specification for Standard Sand*， 2021-12-01 Update
ASTM D1415 Standard Test Method for Rubber Property—International Hardness
ASTM D3666 Standard Specification for Minimum Requirements for Agencies Testing and Inspecting Road and Paving Materials*， 2024-04-21 Update
ASTM D75 Standard Practice for Sampling Aggregates
ASTM E303 Standard Test Method for Measuring Surface Frictional Properties Using the British Pendulum Tester*， 2018-05-01 Update
ASTM E501 Standard Specification for Standard Rib Tire for Pavement Skid-Resistance Tests

2023 ASTM D3319-23 Standard Practice for the Accelerated Polishing of Aggregates Using the British Wheel
2017 ASTM D3319-11(2017) Standard Practice for the Accelerated Polishing of Aggregates Using the British Wheel
2011 ASTM D3319-11 Standard Practice for Accelerated Polishing of Aggregates Using the British Wheel
2006 ASTM D3319-06 Standard Practice for Accelerated Polishing of Aggregates Using the British Wheel
2000 ASTM D3319-00 Standard Practice for Accelerated Polishing of Aggregates Using the British Wheel