ASTM D7425/D7425M-13(2019) PDF

Scope: 1.1 This specification covers the types and physical properties of spray polyurethane foam (SPF) for use in SPF roofing applications. 1.2 This specification does not provide guidance for application. 1.3 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in nonconformance with the standard. 1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

ASTM D7425/D7425M-13(2019) Referenced Document

ASTM C1363 Standard Test Method for the Thermal Performance of Building Assemblies by Means of a Hot Box Apparatus
ASTM C165 Standard Test Method for Measuring Compressive Properties of Thermal Insulations
ASTM C168 Standard Terminology Relating to Thermal Insulation*， 2022-05-01 Update
ASTM C177 Standard Test Method for Steady-State Heat Flux Measurements and Thermal Transmission Properties by Means of the Guarded-Hot-Plate Apparatus
ASTM C518 Standard Test Method for Steady-State Thermal Transmission Properties by Means of the Heat Flow Meter Apparatus
ASTM D1079 Standard Terminology Relating to Roofing and Waterproofing*， 2020-05-01 Update
ASTM D1621 Standard Test Method for Compressive Properties of Rigid Cellular Plastics
ASTM D1622/D1622M Standard Test Method for Apparent Density of Rigid Cellular Plastics*， 2024-04-21 Update
ASTM D1623 Standard Test Method for Tensile And Tensile Adhesion Properties Of Rigid Cellular Plastics
ASTM D2126 Standard Test Method for Response of Rigid Cellular Plastics to Thermal and Humid Aging
ASTM D2842 Standard Test Method for Water Absorption of Rigid Cellular Plastics
ASTM D6226 Standard Test Method for Open Cell Content of Rigid Cellular Plastics
ASTM E96/E96M Standard Test Methods for Gravimetric Determination of Water Vapor Transmission Rate of Materials*， 2024-03-01 Update

2019 ASTM D7425/D7425M-13(2019) Standard Specification for Spray Polyurethane Foam Used for Roofing Applications
2013 ASTM D7425/D7425M-13 Standard Specification for Spray Polyurethane Foam Used for Roofing Applications
2011 ASTM D7425/D7425M-11 Standard Specification for Spray Polyurethane Foam Used for Roofing Applications
2008 ASTM D7425-08 Standard Specification for Spray Polyurethane Foam Used for Roofing Applications