ASTM D4266-17 PDF

Scope: 1.1 These test methods cover the determination of the operating ion-exchange capacity of both powdered cationexchange resins (hydrogen form) and powdered anionexchange resins (hydroxide form). These test methods are intended for use in testing new powdered ion-exchange resins when used for the treatment of water. The following two test methods are included: Sections Test Method A—Operating Capacity, Anion-Exchange Resin, Hydroxide Form 7 to 15 Test Method B—Operating Capacity, Cation-Exchange Resin, Hydrogen Form 16 to 24 1.2 The values stated in SI units are to be regarded as the standard. The inch-pound units given in parentheses are for information only. 1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. 1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

ASTM D4266-17 Referenced Document

ASTM D1125 Standard Test Methods for Electrical Conductivity and Resistivity of Water
ASTM D1129 Standard Terminology Relating to Water
ASTM D1193 Standard Specification for Reagent Water
ASTM D2687 Standard Practices for Sampling Particulate Ion-Exchange Materials
ASTM D4456 Standard Test Methods for Physical and Chemical Properties of Powdered Ion Exchange Resins
ASTM D5391 Standard Test Method for Electrical Conductivity and Resistivity of a Flowing High Purity Water Sample
ASTM E200 Standard Practice for Preparation, Standardization, and Storage of Standard and Reagent Solutions for Chemical Analysis

2017 ASTM D4266-17 Standard Test Methods for Precoat Capacity of Powdered Ion-Exchange Resins
1996 ASTM D4266-96(2009)e1 Standard Test Methods for Precoat Capacity of Powdered Ion-Exchange Resins
1996 ASTM D4266-96(2007) Standard Test Methods for Precoat Capacity of Powdered Ion-Exchange Resins
1996 ASTM D4266-96(2001) Standard Test Methods for Precoat Capacity of Powdered Ion-Exchange Resins
2001 ASTM D4266-96 Standard Test Methods for Precoat Capacity of Powdered Ion-Exchange Resins