ASTM E517-19 PDF

Scope: 1.1 This test method covers special tension testing for the measurement of the plastic strain ratio, r, of sheet metal intended for deep-drawing applications. 1.2 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard. 1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

ASTM E517-19 Referenced Document

ASTM E177 Standard Practice for Use of the Terms Precision and Bias in ASTM Test Methods
ASTM E6 Standard Terminology Relating to Methods of Mechanical Testing
ASTM E691 Standard Practice for Conducting an Interlaboratory Study to Determine the Precision of a Test Method
ASTM E8/E8M Standard Test Methods for Tension Testing of Metallic Materials*， 2024-01-01 Update
ASTM E83 Standard Practice for Verification and Classification of Extensometer
ASTM E92 Standard Test Method for Vickers Hardness of Metallic Materials

2024 ASTM E517-24 Standard Test Method for Plastic Strain Ratio r for Sheet Metal
2019 ASTM E517-19 Standard Test Method for Plastic Strain Ratio r for Sheet Metal
2018 ASTM E517-18 Standard Test Method for Plastic Strain Ratio r for Sheet Metal
2000 ASTM E517-00(2010) Standard Test Method for Plastic Strain Ratio r for Sheet Metal
2000 ASTM E517-00(2006)e1 Standard Test Method for Plastic Strain Ratio r for Sheet Metal
2000 ASTM E517-00(2006) Standard Test Method for Plastic Strain Ratio r for Sheet Metal
2000 ASTM E517-00 Standard Test Method for Plastic Strain Ratio r for Sheet Metal