ASTM E1746-17a PDF

Scope: 1.1 This test method covers sampling and analysis of liquid chlorine for the determination of oxygen (200 to 400 µg/g), nitrogen (400 to 800 µg/g), and carbon dioxide (800 to 1000 ppm) content at levels normally seen in liquid chlorine. Hydrogen and carbon monoxide concentrations in liquid chlorine are typically at or below the detection limit of this test method. NOTE 1—The minimum detection limit of hydrogen using a 1 cm3 gas sample and argon carrier gas is 100 to 200 µg/g.2 The detection limit for the other components is significantly lower. 1.2 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard. 1.3 Review the current Safety Data Sheets (SDS) for detailed information concerning toxicity, first aid procedures, and safety precautions. 1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. Specific hazards statements are given in Section 7. 1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

ASTM E1746-17a Referenced Document

ASTM D6809 Standard Guide for Quality Control and Quality Assurance Procedures for Aromatic Hydrocarbons and Related Materials*， 2020-10-01 Update

2017 ASTM E1746-17a Standard Test Method for Sampling and Analysis of Liquid Chlorine for Gaseous Impurities
2017 ASTM E1746-17 Standard Test Method for Sampling and Analysis of Liquid Chlorine for Gaseous Impurities
2008 ASTM E1746-08 Standard Test Method for Sampling and Analysis of Liquid Chlorine for Gaseous Impurities
1995 ASTM E1746-95(2001)e1 Standard Test Method for Sampling and Analysis of Liquid Chlorine for Gaseous Impurities
1995 ASTM E1746-95 Standard Test Method for Sampling and Analysis of Liquid Chlorine for Gaseous Impurities