ASTM F459-13
Standard Test Methods for Measuring Pull Strength of Microelectronic Wire Bonds

Standard No.

ASTM F459-13

Release Date

2013

Published By

American Society for Testing and Materials (ASTM)

Status

Be replaced

Replace By

ASTM F459-13(2018)

Latest

ASTM F459-13(2018)

Scope

5.1 Failure of microelectronic devices is often due to failure of an interconnection bond. A common type of interconnection bond is a wire bond. These methods can assist in maintaining control of the process of making wire bonds. They can be used to distinguish between weak, nonadherent wire bonds and acceptably strong wire bonds. The methods are destructive.

5.2 These test methods are appropriate for on-line use for process control, for purchase specifications, and for research in support of improved yield or reliability. The referee method should be used for quantitative comparison of pull strengths of wire bonds.

1.1 These test methods cover tests to determine the pull strength of a series of wire bonds. Instructions are provided to modify the methods for use as a referee method. The methods can be used for wire bonds made with wire having a diameter of from 0.0007 to 0.003 in. (18 to 76 ??m).

Note 1???Common usage at the present time considers the term ???wire bond??? to include the entire interconnection: both welds and the intervening wire span.

1.2 These test methods can be used only when the loop height of the wire bond is large enough to allow a suitable hook for pulling (see Fig. 1) to be placed under the wire.

FIG. 1 Suggested Configuration for a Pulling Hook

1.3 The precision of these methods has been evaluated for aluminum ultra-sonic wedge bonds; however, these methods can be used for gold and copper wedge or ball bonds.²

1.4 These methods are destructive. They are appropriate for use in process development or, with a proper sampling plan, for process control or quality assurance.

1.5 A nondestructive procedure is described in Practice F458.

1.6 The values in SI units are to be regarded as standard.

1.7 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

ASTM F459-13 Referenced Document

• ASTM F458 Standard Practice for Nondestructive Pull Testing of Wire Bonds

ASTM F459-13 history

• 2018 ASTM F459-13(2018) Standard Test Methods for Measuring Pull Strength of Microelectronic Wire Bonds
• 2013 ASTM F459-13 Standard Test Methods for Measuring Pull Strength of Microelectronic Wire Bonds
• 2006 ASTM F459-06 Standard Test Methods for Measuring Pull Strength of Microelectronic Wire Bonds
• 2001 ASTM F459-84(2001) Standard Test Methods for Measuring Pull Strength of Microelectronic Wire Bonds
• 2001 ASTM F459-84(1995)e1 Standard Test Methods for Measuring Pull Strength of Microelectronic Wire Bonds