ASTM B197/B197M-20e1
Standard Specification for Copper-Beryllium Alloy Wire

Standard No.
ASTM B197/B197M-20e1
Release Date
2020
Published By
American Society for Testing and Materials (ASTM)
Latest
ASTM B197/B197M-20e1
Scope
1.1 This specification establishes the requirements for copper-beryllium alloy wire in coils, spools, or other than straight lengths, of any uniform cross section. Copper Alloy UNS Nos. C17200 and C173002 are included. 1.2 Unless otherwise required, Copper Alloy UNS No. C17200 shall be the alloy furnished whenever Specification B197/B197M is specified without any alloy designation. 1.3 The values stated in either inch-pounds units or SI units are to be regarded separately as standard. Within the text, the SI units are shown in brackets. The values stated in each system are not necessarily exact equivalents; therefore, to ensure conformance with the standard, each system shall be used independently of the other, and values from the two systems shall not be combined. 1.4 The following safety hazard caveat pertains only to the test methods described in this specification: 1.4.1 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

ASTM B197/B197M-20e1 Referenced Document

  • ASTM B250/B250M Standard Specification for General Requirements for Wrought Copper Alloy Wire
  • ASTM B601 Standard Classification for Temper Designations for Copper and Copper Alloys-Wrought and Cast
  • ASTM B846 Standard Terminology for Copper and Copper Alloys
  • ASTM E112 Standard Test Methods for Determining Average Grain Size
  • ASTM E527 Standard Practice for Numbering Metals and Alloys (UNS)
  • ASTM E8/E8M Standard Test Methods for Tension Testing of Metallic Materials*， 2024-01-01 Update

ASTM B197/B197M-20e1 history

Standard Specification for Copper-Beryllium Alloy Wire


Copyright ©2024 All Rights Reserved