ASTM D6576-20 PDF

Scope: 1.1 This specification establishes requirements for chemically blown cellular rubber. 1.2 In the case of conflict between the provisions of this specification and those of detailed specifications or test methods for a particular product, the latter shall take precedence. 1.3 Unless specifically stated otherwise, by agreement between the purchaser and the supplier, all test methods shall be performed in accordance with the test methods specified in this specification. 1.4 The values stated in SI units are to be regarded as the standard. The inch-pound units given in parentheses are for information only. 1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.6 There is no known ISO equivalent to this specification. NOTE 1—This specification was revised using the updated test methods and specifications in the latest version of Specification D1056. 1.7 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

ASTM D6576-20 Referenced Document

ASTM D1055 Standard Specifications for Flexible Cellular Materials-Latex Foam
ASTM D1056 Standard Specification for Sponge and Expanded Cellular Rubber Products
ASTM D297 Standard Test Methods for Rubber Products-Chemical Analysis
ASTM D471 Standard Test Method for Rubber Property-Effect of Liquids
ASTM D635 Standard Test Method for Rate of Burning and/or Extent and Time of Burning of Plastics in a Horizontal Position
ASTM D883 Standard Terminology Relating to Plastics*， 2024-02-01 Update
ASTM E176 Standard Terminology of Fire Standards
ASTM E177 Standard Practice for Use of the Terms Precision and Bias in ASTM Test Methods
ASTM E2935 Standard Practice for Evaluating Equivalence of Two Testing Processes*， 2021-06-01 Update
ASTM E456 Standard Terminology for Relating to Quality and Statistics
ASTM E691 Standard Practice for Conducting an Interlaboratory Study to Determine the Precision of a Test Method
SAE J1351-1993 Hot Odor Test for Insulation Materials

2020 ASTM D6576-20 Standard Specification for Flexible Cellular Rubber Chemically Blown
2013 ASTM D6576-13 Standard Specification for Flexible Cellular Rubber Chemically Blown
2007 ASTM D6576-07 Standard Specification for Flexible Cellular Rubber Chemically Blown
2000 ASTM D6576-00 Standard Specification for Flexible Cellular Rubber Chemically Blown