ASTM E2779-10(2017) PDF

Scope: 1.1 This test method covers the fueling and operating protocol for determining particulate matter emissions from fires in pellet or other granular or particulate biomass burning room heaters and fireplace inserts. 1.2 The values stated in SI units are to be regarded as standard. The values given in parentheses are mathematical conversions to inch-pound units that are provided for information only and are not considered standard. 1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

ASTM E2779-10(2017) Referenced Document

ASTM D1102 Standard Test Method for Ash in Wood*， 2021-04-01 Update
ASTM D3176 Standard Practice for Ultimate Analysis of Coal and Coke
ASTM D4442 Standard Test Methods for Direct Moisture Content Measurement of Wood and Wood-Base Materials
ASTM D5373 Standard Test Methods for Instrumental Determination of Carbon, Hydrogen, and Nitrogen in Laboratory Samples of Coal and Coke
ASTM E2515 Standard Test Method for Determination of Particulate Matter Emissions Collected by a Dilution Tunnel
ASTM E631 Standard Terminology of Building Constructions
ASTM E711 Standard Test Method for Gross Calorific Value of Refuse-Derived Fuel by the Bomb Calorimeter
ASTM E777 Standard Test Method for Carbon and Hydrogen in the Analysis Sample of Refuse-Derived Fuel
ASTM E778 Standard Test Methods for Nitrogen in the Analysis Sample of Refuse-Derived Fuel
ASTM E871 Standard Test Method for Moisture Analysis of Particulate Wood Fuels*， 2019-04-01 Update
CSA B415.1 Essais de rendement des appareils de chauffage à biocombustibles solides

2017 ASTM E2779-10(2017) Standard Test Method for Determining Particulate Matter Emissions from Pellet Heaters
2010 ASTM E2779-10 Standard Test Method for Determining Particulate Matter Emissions from Pellet Heaters