ASTM D1895-17 PDF

Scope: 1.1 These test methods cover the measurement of apparent density, bulk factor, and where applicable, the pourability of plastic materials such as molding powders. Different procedures are given for application to the various forms of these materials that are commonly encountered, from fine powders and granules to large flakes and cut fibers. 1.2 The values stated in SI units are to be regarded as the standard. The values in parentheses are for information only. 1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health and environmental practices and determine the applicability of regulatory limitations prior to use. NOTE 1—Test Method A is equivalent to ISO Method R 60 as described in the appendix. Test Method C is identical with ISO Method R 61. 1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

ASTM D1895-17 Referenced Document

ASTM D1505 Standard Test Method for Density of Plastics by the Density-Gradient Technique
ASTM D792 Standard Test Methods for Density and Specific Gravity (Relative Density) of Plastics by Displacement
ASTM D883 Standard Terminology Relating to Plastics*， 2024-02-01 Update

2017 ASTM D1895-17 Standard Test Methods for Apparent Density, Bulk Factor, and Pourability of Plastic Materials
1996 ASTM D1895-96(2010)e1 Standard Test Methods for Apparent Density, Bulk Factor, and Pourability of Plastic Materials
1996 ASTM D1895-96(2010) Standard Test Methods for Apparent Density, Bulk Factor, and Pourability of Plastic Materials
1996 ASTM D1895-96(2003) Standard Test Methods for Apparent Density, Bulk Factor, and Pourability of Plastic Materials
1996 ASTM D1895-96 Standard Test Methods for Apparent Density, Bulk Factor, and Pourability of Plastic Materials