ISO 20766-8:2023 PDF

Scope: This document specifies general requirements for the fuel pump component of liquefied petroleum gas fuel, intended for use on the types of motor vehicles as defined in ISO 3833. It also provides general design principles and specifies requirements for instructions and marking. This document is applicable to vehicles (mono-fuel, bi-fuel or dual-fuel applications) using gaseous fuels in accordance with ISO 9162. It is not applicable to the following: a) fuel containers; b) stationary gas engines; c) container mounting hardware; d) electronic fuel management; e) refuelling receptacles. It is recognized that miscellaneous components not specifically addressed herein can be examined for compliance with the criteria of any applicable part of the ISO 20766 series, including testing to the appropriate functional tests. All references to pressure in this document are considered gauge pressures unless otherwise specified. This document applies to device which have a service pressure in the range of 110 kPa (butane rich at 20 °C) and 840 kPa (propane rich at 20 °C), hereinafter referred to in this document. Other service pressures can be accommodated by adjusting the pressure by the appropriate factor (ratio).

ISO 20766-8:2023 Referenced Document

IEC 60529 Degrees of Protection Provided by Enclosures (IP Code) (Edition 2.1 ***Applies to French text only***)*， 2024-04-21 Update
ISO 20766-1 Road vehicles — Liquefied petroleum gas (LPG) fuel systems components — Part 1: General requirements and definitions
ISO 20766-2 Road vehicles — Liquefied petroleum gas (LPG) fuel systems components — Part 2: Performance and general test methods

2023 ISO 20766-8:2023 Road vehicles — Liquefied petroleum gas (LPG) fuel system components — Part 8: Fuel pump