1.1 This test method covers the determination of both dimensions (length and width) and squareness of resilient floor tile. This test method is intended for use with square tiles ranging from a nominal 9 in. (226 mm) to 40 in. (1016 mm) in dimension.
1.2 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
ASTM F2055-17 Referenced Document
ASTM E177 Standard Practice for Use of the Terms Precision and Bias in ASTM Test Methods
ASTM E691 Standard Practice for Conducting an Interlaboratory Study to Determine the Precision of a Test Method
ASTM F2055-17 history
2021ASTM F2055-17(2021) Standard Test Method for Size and Squareness of Resilient Floor Tile by Dial Gauge Method
2017ASTM F2055-17 Standard Test Method for Size and Squareness of Resilient Floor Tile by Dial Gage Method
2010ASTM F2055-10 Standard Test Method for Size and Squareness of Resilient Floor Tile by Dial Gage Method
2009ASTM F2055-09 Standard Test Method for Size and Squareness of Resilient Floor Tile by Dial Gage Method
2000ASTM F2055-00(2008) Standard Test Method for Size and Squareness of Resilient Floor Tile by Dial Gage Method
2000ASTM F2055-00 Standard Test Method for Size and Squareness of Resilient Floor Tile by Dial Gage Method