ASTM ISO/ASTM 51261-13(2020)
Standard Practice for Calibration of Routine Dosimetry Systems for Radiation Processing

Standard No.

ASTM ISO/ASTM 51261-13(2020)

Release Date

2020

Published By

American Society for Testing and Materials (ASTM)

Latest

ASTM ISO/ASTM 51261-13(2020)

Scope

1.1 This practice specifies the requirements for calibrating routine dosimetry systems for use in radiation processing, including establishing measurement traceability and estimating uncertainty in the measured dose using the calibrated dosimetry system. NOTE 1—Regulations or other directives exist in many countries that govern certain radiation processing applications such as sterilization of healthcare products and radiation processing of food requiring that absorbed-dose measurements be traceable to national or international standards (ISO 11137-1, Refs (1-3)2 ). 1.2 The absorbed-dose range covered is up to 1 MGy. 1.3 The radiation types covered are photons and electrons with energies from 80 keV to 25 MeV. 1.4 This document is one of a set of standards that provides recommendations for properly implementing dosimetry in radiation processing, and describes a means of achieving compliance with the requirements of ASTM E2628 “Practice for Dosimetry in Radiation Processing” for the calibration of routine dosimetry systems. It is intended to be read in conjunction with ASTM E2628 and the relevant ASTM or ISO/ASTM standard practice for the dosimetry system being calibrated referenced in Section 2. 1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.6 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

ASTM ISO/ASTM 51261-13(2020) history

• 2020 ASTM ISO/ASTM 51261-13(2020) Standard Practice for Calibration of Routine Dosimetry Systems for Radiation Processing
• 2013 ASTM ISO/ASTM 51261-13 Standard Practice for Calibration of Routine Dosimetry Systems for Radiation Processing
• 2002 ASTM ISO/ASTM 51261-02 Standard Guide for Selection and Calibration of Dosimetry Systems for Radiation Processing