ASTM D3794-18
Standard Guide for Testing Coil Coatings

Standard No.
ASTM D3794-18
Release Date
2018
Published By
American Society for Testing and Materials (ASTM)
Status
Replace By
ASTM D3794-22
Latest
ASTM D3794-22
Scope
1.1 This guide covers procedures for testing coil coatings. The test methods included are listed in Table 1. Where more than one test method is listed for the same characteristic, no attempt is made to indicate superiority of one method over another. Selection of test methods to be followed must be governed by the requirements in each individual case, together with agreement between the producer and user. 1.2 The values stated in SI units are to be regarded as standard. The values given in parentheses are for information only. 1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

ASTM D3794-18 Referenced Document

  • ASTM B117 Standard Practice for Operating Salt Spray (Fog) Apparatus
  • ASTM B368 Standard Method for Copper-Accelerated Acetic Acid-Salt Spray (Fog) Testing (CASS Test)
  • ASTM C1371 Standard Test Method for Determination of Emittance of Materials Near Room Temperature Using Portable Emissometers
  • ASTM C1549 Standard Test Method for Determination of Solar Reflectance Near Ambient Temperature Using a Portable Solar Reflectometer*， 2022-09-01 Update
  • ASTM D1005 Standard Test Method for Measurement of Dry-Film Thickness of Organic Coatings Using Micrometers*， 2020-06-01 Update
  • ASTM D1014 Standard Practice for Conducting Exterior Exposure Tests of Paints on Steel
  • ASTM D1193 Standard Specification for Reagent Water
  • ASTM D1200 Standard Test Method for Viscosity by Ford Viscosity Cup
  • ASTM D1210 Standard Test Method for Fineness of Dispersion of Pigment-Vehicle Systems by Hegman-Type Gage
  • ASTM D1212 Standard Test Methods for Measurement of Wet Film Thickness of Organic Coatings*， 2020-06-01 Update
  • ASTM D1308 Standard Test Method for Effect of Household Chemicals on Clear and Pigmented Organic Finishes
  • ASTM D1474 Standard Test Methods for Indentation Hardness of Organic Coatings
  • ASTM D1475 Standard Test Method For Density of Liquid Coatings, Inks, and Related Products
  • ASTM D1654 Standard Test Method for Evaluation of Painted or Coated Specimens Subjected to Corrosive Environments
  • ASTM D1729 Standard Practice for Visual Appraisal of Colors and Color Differences of Diffusely-Illuminated Opaque Materials
  • ASTM D1735 Standard Practice for Testing Water Resistance of Coatings Using Water Fog Apparatus
  • ASTM D1823 Standard Test Method for Apparent Viscosity of Plastisols and Organosols at High Shear Rates by Extrusion Viscometer
  • ASTM D1824 Standard Test Method for Apparent Viscosity of Plastisols and Organosols at Low Shear Rates
  • ASTM D2092 Standard Guide for Preparation of Zinc-Coated (Galvanized) Steel Surfaces for Painting
  • ASTM D2196 Standard Test Methods for Rheological Properties of Non-Newtonian Materials by Rotational (Brookfield type) Viscometer
  • ASTM D2197 Standard Test Method for Adhesion of Organic Coatings by Scrape Adhesion
  • ASTM D2244 Standard Test Method for Calculation of Color Differences From Instrumentally Measured Color Coordinates
  • ASTM D2247 Standard Practice for Testing Water Resistance of Coatings in 100% Relative Humidity
  • ASTM D2248 Standard Practice for Detergent Resistance of Organic Finishes
  • ASTM D2369 Standard Test Method for Volatile Content of Coatings
  • ASTM D2454 Standard Practice for Determining the Effect of Overbaking on Organic Coatings
  • ASTM D2697 Standard Test Method for Volume Nonvolatile Matter in Clear or Pigmented Coatings
  • ASTM D2794 Standard Test Method for Resistance of Organic Coatings to the Effects of Rapid Deformation (Impact)*， 2024-01-25 Update
  • ASTM D2803 Standard Guide for Testing Filiform Corrosion Resistance of Organic Coatings on Metal
  • ASTM D3003 Standard Test Method for Pressure Mottling and Blocking Resistance of Organic Coatings on Metal Substrates
  • ASTM D3134 Standard Practice for Establishing Color and Gloss Tolerances
  • ASTM D3170 Standard Test Method for Chipping Resistance of Coatings
  • ASTM D3278 Standard Test Methods for Flash Point of Liquids by Small Scale Closed-Cup Apparatus
  • ASTM D3359 Standard Test Methods for Measuring Adhesion by Tape Test
  • ASTM D3361 Standard Practice for Unfiltered Open-Flame Carbon-Arc Exposures of Paint and Related Coatings
  • ASTM D3363 Standard Test Method for Film Hardness by Pencil Test*， 2022-06-01 Update
  • ASTM D3960 Standard Practice for Determining Volatile Organic Compound (VOC) Content of Paints and Related Coatings
  • ASTM D4060 Standard Test Method for Abrasion Resistance of Organic Coatings by the Taber Abraser
  • ASTM D4138 Standard Test Methods for Measurement of Dry Film Thickness of Protective Coating Systems by Destructive Means
  • ASTM D4141 Standard Practice for Conducting Black Box and Solar Concentrating Exposures of Coatings
  • ASTM D4145 Standard Test Method for Coating Flexibility of Prepainted Sheet
  • ASTM D4146 Standard Test Method for Formability of Zinc-Rich Primer/Chromate Complex Coatings on Steel
  • ASTM D4147 Standard Practice for Applying Coil Coatings Using The Wire-Wound Drawdown Bar
  • ASTM D4212 Standard Test Method for Viscosity by Dip-Type Viscosity Cups
  • ASTM D4214 Standard Test Methods for Evaluating the Degree of Chalking of Exterior Paint Films
  • ASTM D4287 Standard Test Method for High-Shear Viscosity Using a Cone/Plate Viscometer
  • ASTM D4518 Standard Test Methods for Measuring Static Friction of Coating Surfaces
  • ASTM D4585 Standard Practice for Testing Water Resistance of Coatings Using Controlled Condensation
  • ASTM D4587 Standard Practice for Fluorescent UV-Condensation Exposures of Paint and Related Coatings
  • ASTM D5031 Standard Practice for Enclosed Carbon-Arc Exposure Tests of Paint and Related Coatings
  • ASTM D5178 Standard Test Method for Mar Resistance of Organic Coatings
  • ASTM D522 Standard Test Methods for Mandrel Bend Test of Attached Organic Coatings
  • ASTM D523 Standard Test Method for Specular Gloss
  • ASTM D5402 Standard Practice for Assessing the Solvent Resistance of Organic Coatings Using Solvent Rubs
  • ASTM D5531 Standard Guide for Preparation, Maintenance, and Distribution of Physical Product Standards for Color and Geometric Appearance of Coatings
  • ASTM D5723 Standard Practice for Determination of Chromium Treatment Weight on Metal Substrates by X-Ray Fluorescence*， 2019-12-01 Update
  • ASTM D5796 Standard Test Method for Measurement of Dry Film Thickness of Thin Film Coil-Coated Systems by Destructive Means Using a Boring Device
  • ASTM D5894 Standard Practice for Cyclic Salt Fog/UV Exposure of Painted Metal, (Alternating Exposures in a Fog/Dry Cabinet and a UV/Condensation Cabinet)
  • ASTM D6093 Standard Test Method for Percent Volume Nonvolatile Matter in Clear or Pigmented Coatings Using a Helium Gas Pycnometer*， 2022-12-01 Update
  • ASTM D610 Standard Test Method for Evaluating Degree of Rusting on Painted Steel Surfaces
  • ASTM D6491 Standard Practice for Evaluation of Aging Resistance of Prestressed Prepainted Metal In a Dry Heat Test
  • ASTM D6492 Standard Practice for Detection of Hexavalent Chromium On Zinc and Zinc/Aluminum Alloy Coated Steel*， 2022-06-01 Update
  • ASTM D6578 Standard Practice for Determination of Graffiti Resistance*， 2024-04-20 Update
  • ASTM D660 Standard Test Method for Evaluating Degree of Checking of Exterior Paints*， 2019-10-01 Update
  • ASTM D661 Standard Test Method for Evaluating Degree of Cracking of Exterior Paints*， 2019-10-01 Update
  • ASTM D6665 Standard Practice for Evaluation of Aging Resistance of Pre-stressed Prepainted Metal in a Boiling Water Test*， 2024-02-01 Update
  • ASTM D6695 Standard Practice for Xenon-Arc Exposures of Paint and Related Coatings*， 2024-04-20 Update
  • ASTM D6906 Standard Test Method for Determination of Titanium Treatment Weight on Metal Substrates by Wavelength Dispersive X-Ray Fluorescence*， 2021-11-01 Update
  • ASTM D6944 Standard Practice for Determining the Resistance of Cured Coatings to Thermal Cycling*， 2020-02-01 Update
  • ASTM D7091 Standard Practice for Nondestructive Measurement of Dry Film Thickness of Nonmagnetic Coatings Applied to Ferrous Metals and Nonmagnetic, Nonconductive Coatings Applied to Non-Ferrous Metals*， 2022-06-01 Update
  • ASTM D714 Standard Test Method for Evaluating Degree of Blistering of Paints
  • ASTM D7376 Standard Practice for Outdoor Evaluation of Wet Stack Storage Conditions on Coil-Coated Metals*， 2022-06-01 Update
  • ASTM D7639 Standard Test Method for Determination of Zirconium Treatment Weight or Thickness on Metal Substrates by X-Ray Fluorescence*， 2022-12-01 Update
  • ASTM D7835/D7835M Standard Test Method for Determining the Solvent Resistance of an Organic Coating Using a Mechanical Rubbing Machine*， 2023-10-01 Update
  • ASTM D7869 Standard Practice for Xenon Arc Exposure Test with Enhanced Light and Water Exposure for Transportation Coatings
  • ASTM D7897 Standard Practice for Laboratory Soiling and Weathering of Roofing Materials to Simulate Effects of Natural Exposure on Solar Reflectance and Thermal Emittance
  • ASTM D822 Standard Practice for Filtered Open-Flame Carbon-Arc Exposures of Paint and Related Coatings
  • ASTM D823 Standard Practices for Producing Films of Uniform Thickness of Paint, Varnish, and Related Products on Test Panels
  • ASTM D870 Standard Practice for Testing Water Resistance of Coatings Using Water Immersion
  • ASTM D968 Standard Test Methods for Abrasion Resistance of Organic Coatings by Falling Abrasive
  • ASTM E1164 Standard Practice for Obtaining Spectrophotometric Data for Object-Color Evaluation
  • ASTM E1356 Standard Test Method for Assignment of the Glass Transition Temperatures by Differential Scanning Calorimetry or Differential Thermal Analysis
  • ASTM E1541 Standard Practice for Specifying and Matching Color Using the Colorcurve System
  • ASTM E1545 Standard Test Method for Assignment of the Glass Transition Temperature by Thermomechanical Analysis*， 2022-04-01 Update
  • ASTM E1640 Standard Test Method for Assignment of the Glass Transition Temperature By Dynamic Mechanical Analysis
  • ASTM E1808 Standard Guide for Designing and Conducting Visual Experiments*， 2024-04-20 Update
  • ASTM E1918 Standard Test Method for Measuring Solar Reflectance of Horizontal and Low-Sloped Surfaces in the Field
  • ASTM E1980 Standard Practice for Calculating Solar Reflectance Index of Horizontal and Low-Sloped Opaque Surfaces
  • ASTM E284 Standard Terminology of Appearance
  • ASTM E308 Standard Practice for Computing the Colors of Objects by Using the CIE System
  • ASTM E408 Standard Test Methods for Total Normal Emittance of Surfaces Using Inspection-Meter Techniques
  • ASTM E643 Standard Test Method for Ball Punch Deformation of Metallic Sheet Material
  • ASTM E70 Standard Test Method for pH of Aqueous Solutions With the Glass Electrode
  • ASTM E84 Standard Test Method for Surface Burning Characteristics of Building Materials
  • ASTM E903 Standard Test Method for Solar Absorptance, Reflectance, and Transmittance of Materials Using Integrating Spheres
  • ASTM G113 Standard Terminology Relating to Natural and Artificial Weathering Tests of Nonmetallic Materials
  • ASTM G151 Standard Practice for Exposing Nonmetallic Materials in Accelerated Test Devices that Use Laboratory Light Sources
  • ASTM G152 Standard Practice for Operating Open Flame Carbon Arc Light Apparatus for Exposure of Nonmetallic Materials*， 2024-04-20 Update
  • ASTM G153 Standard Practice for Operating Enclosed Carbon Arc Light Apparatus for Exposure of Nonmetallic Materials*， 2021-06-01 Update
  • ASTM G154 Standard Practice for Operating Fluorescent Ultraviolet (UV) Lamp Apparatus for Exposure of Materials*， 2023-01-01 Update
  • ASTM G155 Standard Practice for Operating Xenon Arc Lamp Apparatus for Exposure of Materials*， 2024-04-20 Update
  • ASTM G60 Standard Practice for Conducting Cyclic Humidity Tests
  • ASTM G7 Standard Practice for Atmospheric Environmental Exposure Testing of Nonmetallic Materials
  • ASTM G85 Standard Practice for Modified Salt Spray (Fog) Testing
  • ASTM G87 Standard Practice for Conducting Moist SO2 Tests
  • ASTM G90 Standard Practice for Performing Accelerated Outdoor Weathering of Nonmetallic Materials Using Concentrated Natural Sunlight

ASTM D3794-18 history

Standard Guide for Testing Coil Coatings


Copyright ©2024 All Rights Reserved