ASTM G224-23
Standard Practice for Operating UVC Lamp Apparatus for Exposure of Materials

Standard No.

ASTM G224-23

Release Date

2023

Published By

American Society for Testing and Materials (ASTM)

Latest

ASTM G224-23

Scope

1.1 This practice is limited to the basic principles for operating a low-pressure mercury lamp apparatus to assess degradation of materials due to exposure to UVC light; on its own, it does not deliver a specific result. 1.2 It is intended to be used in conjunction with a practice or method that defines specific exposure conditions for an application along with a means to evaluate changes in material properties. This practice is intended to reproduce the photodegradation effects that occur when materials are exposed to artificial light sources that emit radiation primarily in the UVC wavelength band, particularly in the range of 240 nm to 280 nm. This practice is limited to the procedures for obtaining, measuring, and controlling conditions of exposure. NOTE 1—Practice G151 describes general procedures to be used when exposing materials in accelerated test devices that use laboratory light sources. NOTE 2—A common use of UVC light sources is for the disinfection of surfaces and air, a process known as ultraviolet germicidal irradiation (UVGI). Water disinfection applications using UVC light sources have been in use for many decades. 1.3 This practice does not cover other light sources (e.g. LEDs, excimer lamps, etc.) or any lamps that emit wavelengths primarily outside the range in 1.2. 1.4 Specimens are exposed to UVC light controlled to a specified irradiance level under controlled temperature conditions. 1.5 Specimen preparation and evaluation of the results are covered in ASTM methods or specifications for specific materials. General guidance is given in Practice G151. 1.6 Units—The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard. 1.7 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.8 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

ASTM G224-23 Referenced Document

• ASTM G113 Standard Terminology Relating to Natural and Artificial Weathering Tests of Nonmetallic Materials
• ASTM G130 Standard Test Method for Calibration of Narrow- and Broad-Band Ultraviolet Radiometers Using a Spectroradiometer
• ASTM G151 Standard Practice for Exposing Nonmetallic Materials in Accelerated Test Devices that Use Laboratory Light Sources
• ASTM G154 Standard Practice for Operating Fluorescent Ultraviolet (UV) Lamp Apparatus for Exposure of Materials

ASTM G224-23 history

• 2023 ASTM G224-23 Standard Practice for Operating UVC Lamp Apparatus for Exposure of Materials