ASTM E2230-13
Standard Practice for Thermal Qualification of Type B Packages for Radioactive Material

Standard No.

ASTM E2230-13

Release Date

2013

Published By

American Society for Testing and Materials (ASTM)

Status

Be replaced

Replace By

ASTM E2230-22

Latest

ASTM E2230-22

Scope

5.1 The major objective of this practice is to provide a common reference document for both applicants and certification authorities on the accepted practices for accomplishing package thermal qualification. Details and methods for accomplishing qualification are described in this document in more specific detail than available in the regulations. Methods that have been shown by experience to lead to successful qualification are emphasized. Possible problems and pitfalls that lead to unsatisfactory results are also described.

5.2 The work described in this standard practice shall be done under a quality assurance program that is accepted by the regulatory authority that certifies the package for use. For packages certified in the United States, 10 CFR 71 Subpart H shall be used as the basis for the quality assurance (QA) program, while for international certification, ISO 9000 usually defines the appropriate program. The quality assurance program shall be in place and functioning prior to the initiation of any physical or analytical testing activities and prior to submittal of any information to the certifying authority.

5.3 The unit system (SI metric or English) used for thermal qualification shall be agreed upon prior to submission of information to the certification authority. If SI units are to be standard, then use IEEE/ASTM8201;SI-10. Additional units given in parentheses are for information purposes only.

1.1 This practice defines detailed methods for thermal qualification of “Type B” radioactive materials packages under Title 10, Code of Federal Regulations, Part 71 (10CFR71) in the United States or, under International Atomic Energy Agency Regulation TS-R-1. Under these regulations, packages transporting what are designated to be Type B quantities of radioactive material shall be demonstrated to be capable of withstanding a sequence of hypothetical accidents without significant release of contents.

1.2 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

1.3 This standard is used to measure and describe the response of materials, products, or assemblies to heat and flame under controlled conditions, but does not by itself incorporate all factors required for fire hazard or fire risk assessment of the materials, products, or assemblies under actual fire conditions.

1.4 Fire testing is inherently hazardous. Adequate safeguards for personnel and property shall be employed in conducting these tests.

ASTM E2230-13 Referenced Document

• ASTM E176 Standard Terminology of Fire Standards
• IEEE/ASTM SI 10 American National Standard for Metric Practice

ASTM E2230-13 history

• 2022 ASTM E2230-22 Standard Practice for Thermal Qualification of Type B Packages for Radioactive Material
• 2013 ASTM E2230-13 Standard Practice for Thermal Qualification of Type B Packages for Radioactive Material
• 2008 ASTM E2230-08 Standard Practice for Thermal Qualification of Type B Packages for Radioactive Material
• 2002 ASTM E2230-02 Standard Practice for Thermal Qualification of Type B Packages for Radioactive Material