ASTM C1857/C1857M-19
Standard Test Method for Evaluating the Adhesion (Pull-Off) Strength of Concrete Repair and Overlay Mortar

Standard No.

ASTM C1857/C1857M-19

Release Date

2019

Published By

American Society for Testing and Materials (ASTM)

Latest

ASTM C1857/C1857M-19

Scope

1.1 This test method is suitable for laboratory use to determine one or more of the following: 1.1.1 The bond strength of a repair or an overlay material to a specific concrete substrate. 1.1.2 The tensile strength of a repair or overlay material after the material has been applied to the concrete substrate. 1.1.3 The change in bond strength when applying a bonding agent or other bond modifying treatment to the concrete substrate. 1.2 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system are not necessarily exact equivalents; therefore, to ensure conformance with the standard, each system shall be used independently of the other, and values from the two systems shall not be combined. Some values have only SI units because the inch-pound equivalents are not used in practice. 1.2.1 If required results obtained from another standard are not reported in the same system of units as used by this test method, it is permitted to convert those results using the conversion factors found in the SI Quick Reference Guide.2 1.3 The text of this test method refers to notes and footnotes that provide explanatory material. These notes and footnotes (excluding those in tables and figures) shall not be considered as requirements of this test method. 1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. (Warning—Fresh hydraulic cementitious mixtures are caustic and may cause chemical burns to skin and tissue upon prolonged exposure.)3 1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

ASTM C1857/C1857M-19 Referenced Document

• ASTM C1107/C1107M Standard Specification for Packaged Dry, Hydraulic-Cement Grout (Nonshrink)*， 2020-02-01 Update
• ASTM C125 Standard Terminology Relating to Concrete and Concrete Aggregates*， 2021-10-01 Update
• ASTM C1583/C1583M Standard Test Method for Tensile Strength of Concrete Surfaces and the Bond Strength or Tensile Strength of Concrete Repair and Overlay Materials by Direct Tension (Pull-off Method)*， 2020-04-01 Update
• ASTM C191 Standard Test Method for Time of Setting of Hydraulic Cement by Vicat Needle
• ASTM C305 Standard Practice for Mechanical Mixing of Hydraulic Cement Pastes and Mortars of Plastic Consistency
• ASTM C702/C702M Standard Practice for Reducing Samples of Aggregate to Testing Size
• ASTM C881/C881M Standard Specification for Epoxy-Resin-Base Bonding Systems for Concrete*， 2020-10-01 Update
• ASTM C900 Standard Test Method for Pullout Strength of Hardened Concrete
• ASTM E4 Standard Practices for Force Verification of Testing Machines
• ASTM E74 Standard Practices for Calibration and Verification for Force-Measuring Instruments
• ISO 13007-2 Ceramic tiles.Grouts and adhesives.Part 2: Test methods for adhesives

ASTM C1857/C1857M-19 history

• 2019 ASTM C1857/C1857M-19 Standard Test Method for Evaluating the Adhesion (Pull-Off) Strength of Concrete Repair and Overlay Mortar