ASTM E2298-18 PDF

Scope: 1.1 This test method establishes the requirements for performing instrumented Charpy V-notch (CVN) and instrumented miniaturized Charpy V-notch (MCVN) impact tests on metallic materials. This method, which is based on experience developed testing steels, provides further information (in addition to the absorbed energy) on the fracture behavior of the tested materials. Minimum requirements are given for measurement and recording equipment such that similar sensitivity and comparable absorbed energy measurements to those obtained in Test Methods E23 and E2248 are achieved. 1.2 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard. 1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

ASTM E2298-18 Referenced Document

ASTM E177 Standard Practice for Use of the Terms Precision and Bias in ASTM Test Methods
ASTM E2248 Standard Test Method for Impact Testing of Miniaturized Charpy V-notch Specimens
ASTM E23 Standard Test Methods for Notched Bar Impact Testing of Metallic Materials
ASTM E4 Standard Practices for Force Verification of Testing Machines
ASTM E691 Standard Practice for Conducting an Interlaboratory Study to Determine the Precision of a Test Method
ISO 14556 Metallic materials — Charpy V-notch pendulum impact test — Instrumented test method*， 2023-05-01 Update

2018 ASTM E2298-18 Standard Test Method for Instrumented Impact Testing of Metallic Materials
2015 ASTM E2298-15 Standard Test Method for Instrumented Impact Testing of Metallic Materials
2013 ASTM E2298-13a Standard Test Method for Instrumented Impact Testing of Metallic Materials
2013 ASTM E2298-13 Standard Test Method for Instrumented Impact Testing of Metallic Materials
2009 ASTM E2298-09 Standard Test Method for Instrumented Impact Testing of Metallic Materials