ASTM D3320/D3320M-18 PDF

Scope: 1.1 This specification covers mineral-colloid-stabilized, emulsified coal-tar pitch suitable for use as a weatherprotective and aliphatic-solvent resistant coating over bituminous pavements of airports, parking areas, and driveways. 1.2 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard. 1.3 The following precautionary caveat pertains only to the test method portion, Section 6, of this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

ASTM D3320/D3320M-18 Referenced Document

ASTM D140/D140M Standard Practice for Sampling Asphalt Materials*， 2023-12-01 Update
ASTM D2939 Standard Test Methods for Emulsified Bitumens Used as Protective Coatings
ASTM D3699 Standard Specification for Kerosine
ASTM D490 Standard Specification for Road Tar
ASTM D529 Standard Practice for Enclosed Carbon-Arc Exposures of Bituminous Materials *， 2024-04-20 Update

2018 ASTM D3320/D3320M-18 Standard Specification for Emulsified Coal-Tar Pitch (Mineral Colloid Type)
2000 ASTM D3320-00(2004)e1 Standard Specification for Emulsified Coal-Tar Pitch (Mineral Colloid Type)
2000 ASTM D3320-00 Standard Specification for Emulsified Coal-Tar Pitch (Mineral Colloid Type)