ASTM D3124-98(2019) PDF

Scope: 1.1 This test method is applicable to all types of polyethylenes, those ethylene plastics consisting of ethylene and α-olefin copolymers longer than propylene, and blends of the above in any ratio. 1.2 The values stated in SI units are to be regarded as the standard. 1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. Specific hazards statements are given in Section 8. NOTE 1—There is no known ISO equivalent to this standard. 1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

ASTM D3124-98(2019) Referenced Document

ASTM D1505 Standard Test Method for Density of Plastics by the Density-Gradient Technique
ASTM D1898
ASTM D792 Standard Test Methods for Density and Specific Gravity (Relative Density) of Plastics by Displacement
ASTM E131 Standard Definitions of Terms and Symbols Relating to Molecular Spectroscopy
ASTM E168 Standard Practices for General Techniques of Infrared Quantitative Analysis
ASTM E177 Standard Practice for Use of the Terms Precision and Bias in ASTM Test Methods
ASTM E275 Standard Practice for Describing and Measuring Performance of Ultraviolet, Visible, and Near-Infrared Spectrophotometers
IEEE/ASTM SI 10 American National Standard for Metric Practice

2019 ASTM D3124-98(2019) Standard Test Method for Vinylidene Unsaturation in Polyethylene by Infrared Spectrophotometry
1998 ASTM D3124-98(2011) Standard Test Method for Vinylidene Unsaturation in Polyethylene by Infrared Spectrophotometry
2003 ASTM D3124-98(2003) Standard Test Method for Vinylidene Unsaturation in Polyethylene by Infrared Spectrophotometry
1998 ASTM D3124-98 Standard Test Method for Vinylidene Unsaturation in Polyethylene by Infrared Spectrophotometry