ASTM D6524/D6524M-16(2021) PDF

Scope: 1.1 This test method covers the resiliency or recovery of turf reinforcement mats (TRMs) after they have been subjected to three cycles of loading at 689 kPa [100 psi] for 1 min/per cycle. 1.2 This test method does not provide resiliency values for TRMs under variable normal compressive stresses. This test method determines nominal resiliency. 1.3 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system are not necessarily exact equivalents; therefore, to ensure conformance with the standard, each system shall be used independently of the other, and values from the two systems shall not be combined. 1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

ASTM D6524/D6524M-16(2021) Referenced Document

2021 ASTM D6524/D6524M-16(2021) Standard Test Method for Measuring the Resiliency of Turf Reinforcement Mats (TRMs)
2016 ASTM D6524/D6524M-16 Standard Test Method for Measuring the Resiliency of Turf Reinforcement Mats (TRMs)
2000 ASTM D6524-00(2011) Standard Test Method for Measuring the Resiliency of Turf Reinforcement Mats (TRMs)
2000 ASTM D6524-00(2006) Standard Test Method for Measuring the Resiliency of Turf Reinforcement Mats (TRMs)
2000 ASTM D6524-00 Standard Test Method for Measuring the Resiliency of Turf Reinforcement Mats (TRMs)