ASTM D1304-99
Standard Test Methods for Adhesives Relative to Their Use as Electrical Insulation

Standard No.

ASTM D1304-99

Release Date

1999

Published By

American Society for Testing and Materials (ASTM)

Status

Be replaced

Replace By

ASTM D1304-99(2005)

Latest

ASTM D1304-99(2020)e1

Scope

1.1 These test methods cover procedures for testing adhesives in liquid, highly viscous, solid, or set states, that are intended to be cured by electronic heating, or that are intended to provide electrical insulation, or that are intended for use in electrical apparatus.

1.2 The procedures appear in the following order: (1) Procedure for Testing Adhesives Before Use:

Section Power Factor and Dielectric Constant of Liquid Adhesives 7 Direct-Current Conductivity 8 Extract Conductivity 9 Acidity and Alkalinity 10 pH Value 11 Section Power Factor and Dielectric Constant of a Dried or Cured Adhesive Film 12 Dielectric Strength 13 Volume and Surface Resistivity 14 Arc Resistance 15

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use . For a specific hazard statement, see 8.2.

ASTM D1304-99 history

• 2020 ASTM D1304-99(2020)e1 Standard Test Methods for Adhesives Relative to Their Use as Electrical Insulation
• 1999 ASTM D1304-99(2012) Standard Test Methods for Adhesives Relative to Their Use as Electrical Insulation
• 2005 ASTM D1304-99(2005) Standard Test Methods for Adhesives Relative to Their Use as Electrical Insulation
• 1999 ASTM D1304-99 Standard Test Methods for Adhesives Relative to Their Use as Electrical Insulation