ASTM C679-15(2022) PDF

Scope: 1.1 This test method covers a procedure for the determination of the tack-free time property of singleand multicomponent elastomeric sealants commonly used for sealing, caulking, and glazing in buildings and related construction. 1.2 This test method is applicable to self-leveling and non-sag grades of sealant. Sealants requiring slight heating to facilitate extrusion from the cartridge or gun are also described by this test method. NOTE 1—See Specification C920 for type and grade definitions. 1.3 The values stated in SI units are to be regarded as standard. The values given in parentheses after SI units are provided for information only and are not considered standard. 1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. NOTE 2—Currently, there is no ISO standard similar to this specification. 1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

ASTM C679-15(2022) Referenced Document

2022 ASTM C679-15(2022) Standard Test Method for Tack-Free Time of Elastomeric Sealants
2015 ASTM C679-15 Standard Test Method for Tack-Free Time of Elastomeric Sealants
2003 ASTM C679-03(2009)e1 Standard Test Method for Tack-Free Time of Elastomeric Sealants
2003 ASTM C679-03 Standard Test Method for Tack-Free Time of Elastomeric Sealants
1987 ASTM C679-87(1997)e1 Standard Test Method for Tack-Free Time of Elastomeric Sealants