ASTM D3716-14(2020) PDF

Scope: 1.1 These test methods cover test procedures for emulsion polymers that are used in water-based floor polishes. The term “emulsion polymers” is used primarily to denote those materials produced by regular emulsion polymerization techniques, but may be extended to those polymers that are subsequently emulsified or dispersed after polymerization. Unless otherwise noted, the tests may be used for any polymer or copolymer systems. The methods appear in the following order: Section Sampling 4 Total Solids 5 pH Value 6 Apparent Viscosity 7 Sediment 8 Storage Stability 9 Freeze-thaw Stability 10 Specific Gravity 11 1.2 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.3 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

ASTM D3716-14(2020) Referenced Document

ASTM E1 Standard Specification for ASTM Thermometers
ASTM E100 Standard Specification for ASTM Hydrometers
ASTM E70 Standard Test Method for pH of Aqueous Solutions With the Glass Electrode

2020 ASTM D3716-14(2020) Standard Test Methods for Use of Emulsion Polymers in Floor Polishes
2014 ASTM D3716-14 Standard Test Methods for Use of Emulsion Polymers in Floor Polishes
1999 ASTM D3716-99(2008) Standard Test Methods for Use of Emulsion Polymers in Floor Polishes
1999 ASTM D3716-99(2006) Standard Test Methods for Use of Emulsion Polymers in Floor Polishes
1999 ASTM D3716-99 Standard Test Methods for Use of Emulsion Polymers in Floor Polishes