BS EN 1565-1:2000 Plastics piping systems for soil and waste discharge (low and high temperature) within the building structure. Styrene copolymer blends (SAN + PVC). Specifications for pipes, fittings and the system
This European Standard specifies the requirements for pipes, fittings and the system of styrene copolymer blends (SAN+PVC) solid-wall piping systems in the field of soil and waste discharge (low and high temperature) inside buildings (marked with "B") and for soil and waste discharge systems for both inside buildings and buried in ground within the building structure (marked with "BD").
NOTE 1: The application area "inside buildings" according to this standard, applies to the interior area of the building only. The application area "within the building structure" conforms to the requirements for "inside buildings" according to prEN 12056-1.
It also specifies the test parameters for the test methods referred to in this standard.
This standard is applicable to (SAN+PVC) pipes and fittings, their joints and to joints with components of other plastics and non-plastics materials intended to be used for the following purposes:
a) soil and waste discharge pipework for the conveyance of domestic waste waters (low and high temperature);
b) ventilation pipework associated with a);
c) rainwater pipework within the building structure.
It applies to pipes and fittings, marked with "B", which are intended to be used inside buildings and outside buildings fixed onto the wall.
It applies to pipes and fittings, marked with "BD", which are intended to be used for both inside buildings and buried in ground within the building structure.
NOTE 2: Only components marked with "BD" are generally to be used buried in ground within the building structure; these are required to have a nominal ring stiffness of at least SN 4 and a nominal outside diameter equal or greater than 75 mm.
NOTE 3: Pipes and fittings of the pipe series S 25 are intended to be used for application area "B" only.
This standard is applicable to (SAN+PVC) pipes and fittings of the following types:
- plain-ended;
- with integral elastomeric ring seal socket;
- with integral solvent cement socket;
- with integral dual purpose socket for elastomeric ring seal joints and/or solvent cement joints,
whereby the fittings can be manufactured by injection-moulding or be fabricated from pipes and/or mouldings.
NOTE 4: Components conforming to any of the Product Standards listed in the bibliography can be used with pipes and fittings conforming to this standard, provided they conform to the requirements for joint dimensions and to the functional requirements given in this standard.
This standard covers a range of nominal sizes, a range of pipe series and gives recommendations concerning colours.
NOTE 5: It is the responsibility of the purchaser or specifier to make the appropriate selection from these aspects, taking into account their particular requirements and any relevant national regulations and installation practices codes.
BS EN 1565-1:2000 history
2014BS EN 1329-1:2014 Plastics piping systems for soil and waste discharge (low and high temperature) within the building structure. Unplasticized poly(vinyl chloride) (PVC-U). Specifications for pipes, fittings and the system
2000BS EN 1329-1:2000 Plastics piping systems for soil and waste discharge (low and high temperature) within the building structure. Unplasticized poly(vinyl chloride) (PVC-U). Specifications for pipes, fittings and the system
1989BS 5255:1989 Specification for thermoplastics waste pipe and fittings